Löyly physics
Löyly physics describes the coupled phase change, energy transfer and moist-air transport that follow when water is applied to heated sauna stones. The Finnish meaning and practice belong to Löyly and Finnish sauna culture; the physical event begins with energy leaving the heater–stone system and entering the water. Only part of the applied liquid may become vapour, and the resulting field is neither steady nor spatially uniform. A strong rise in perceived heat therefore does not show that the whole sauna has undergone a comparable rise in air temperature.[1]
The event is a short-lived part of the wider Sauna climate and a process within Sauna technology. It joins processes at the stone bed, in the moving air, at room surfaces and at a bather. Treating it as an open mass-and-energy balance avoids two common but incompatible simplifications: that the added water creates heat, and that all water disappears instantly into a room full of pure steam.
Energy transfer at the stone bed
During water application, liquid must first be warmed. The fraction that changes phase must also receive the enthalpy required for vaporisation, and the resulting vapour may be heated further. The relevant heat capacity, enthalpy and vapour–liquid equilibrium properties vary with thermodynamic state; IAPWS-95 provides a scientific formulation for these properties rather than one constant suitable for every calculation.[2]
The applied mass is not automatically the vapour mass delivered to the room. Liquid can wet or pass through the bed, drain, splash, or be carried as droplets; some can remain while the contacted surfaces cool. A complete balance would distinguish each of those paths. The everyday word Steam can include a visible mist, but gaseous water vapour is normally invisible, whereas visible material consists of droplets or other particles.[3] Detailed evaporation rates cannot be inferred from the poured volume alone.
Heat storage in the stones permits a large transfer over a short period. Continued heater output and heat conducted from less-cooled parts subsequently contribute to recovery. The Finnish Sauna Society distinguishes heat-storing and continuously heated heater arrangements and notes that the amount of stone depends on heater output and model.[4] Stone mass by itself consequently says little about one pour: initial temperature distribution, wetted area, packing, material properties, heater operation and the interval since a previous application also matter. No retained source establishes a universal stone temperature, dose or recovery interval.
From the heater to the room
Vapour, entrained air and any droplets enter circulation around the heater and mix with room air. Under equal temperature and total-pressure assumptions, psychrometric relations predict a lower density for a moister air mixture because water has a lower molecular mass than dry air. An actual löyly plume does not hold those other variables constant: its temperature, composition and velocity change together, and heater-driven circulation and ventilation are already present.[5] “Steam rises” is therefore shorthand, not a complete prediction of the path or arrival time.
Direct sauna evidence is installation-specific. VTT experiments in rooms with mechanical extract ventilation examined humidity distribution during water casting. In those arrangements, inlet and outlet placement and the resulting mixing affected whether the temperature and humidity response extended into the lower room.[6] This supports the importance of airflow and mixing, but not one universal vent layout or vertical profile.
Nore and colleagues deliberately modified a single spruce-lined test room: the door frame was sealed, a ceiling duct closed, and most of the heater covered with aluminium foil for thermography. After one-, two- and three-litre applications, relative humidity rose abruptly and measured spruce ceiling temperature increased by about 2.5 °C, while the reported room-air increase was 0.5 °C or less.[1] The authors attributed the surface response to moisture sorption by dry wood. Heater cycling, unusually large additions, the altered enclosure and the absence of a complete water balance prevent those magnitudes from being transferred to ordinary use.
Moisture can subsequently leave with exhaust air, deposit on a cooler boundary, or be taken up temporarily by hygroscopic material. Door movement and occupants further change the open system. The amount reaching any seat is therefore not simply the poured mass divided by room volume.
Humidity during the pulse
Successful vaporisation raises local water-vapour partial pressure. Relative humidity commonly rises too, but it is a ratio to saturation pressure at the same temperature. Absolute humidity is vapour mass per volume, while humidity ratio uses a mass denominator; Dew point expresses the saturation temperature associated with a vapour state.[5] These quantities answer different questions and should retain their units and assumptions. Their fuller definitions belong in the individual articles and the sauna glossary.
A frequently repeated historical value illustrates the risk of relabelling. The abstract of Helamaa and Äikäs’s 1988 paper describes 40–60 grams per kilogram “of air” as a suitable moisture range.[7] The accessible text does not identify whether the denominator is dry air or total moist air. It must not be silently converted into an ASHRAE humidity ratio, and its units are neither percentage RH nor grams per cubic metre. It is also an old recommendation about “good” löyly, not a universal phase-change threshold.
A 2026 experiment used six paired temperature-and-RH measurement positions—three horizontal locations at each of two heights—while 50 healthy, recreationally active adults completed four ten-minute rounds and controlled their own water applications.[8] The observed temperature–RH combinations differed substantially by height. The study demonstrates sampling dependence; it did not measure a complete vapour plume or randomise a water-vapour dose.
Exchange with bathers and surfaces
The bather receives sensible heat through moving air and radiation while losing heat through sweat evaporation; condensation can add latent energy at a cooler surface. A short 1996 conference model treated sensible and latent skin fluxes together and predicted a pronounced increase after water casting under its assumptions.[9] The University of Helsinki classifies it as a non-peer-reviewed conference contribution, so it explains a mechanism rather than providing a universal multiplier for Heat transfer in a sauna.
Higher vapour pressure narrows the vapour-pressure difference available for sweat evaporation. If adjacent air has a dew point above local skin temperature, condensation is thermodynamically possible and releases latent energy at the phase boundary. Actual rates also depend on skin wetness, air velocity and boundary-layer transport. A stable-isotope experiment gave direct evidence that labelled casting water contributed to liquid dripping from participants: mean estimated condensate fractions ranged from about 30 to 54 per cent across two experiments and two calculation methods.[10] These percentages describe collected dripping liquid in those protocols, not all skin moisture and not the share of total heat transfer due to condensation.
In the 2026 study, temperature and RH were each associated with acute heart-rate and core-temperature changes in adjusted models, but humidity had not been assigned independently. A calculated dew-point-minus-skin-temperature index had weak or inconsistent associations with heart rate and none with core-temperature change.[8] The four short rounds, selected sample, different heaters and participant-controlled pouring restrict causal interpretation. Harvia supplied the research infrastructure and publication costs, while Toyota partly funded the measurement phase. The results do not establish an ideal humidity, a safety threshold or a health benefit.
Water vapour can also participate in long-wave radiation. In one Japanese field-and-modelling study, including gas absorption improved the mean-radiant-temperature estimate by about 1 °C at one location roughly four metres from a cooled window, compared with a transparent-gas model.[11] That result depends on geometry and model and does not quantify the radiative effect of a single pour in another room.
Repetition, distribution and measurement
Successive applications begin from different states. Contacted stones may not have recovered thermally, surfaces and room air may hold more moisture, and water may follow a different route through the bed. Practical placement and pacing belong to Sauna ladle technique, not to a universal equation derived from water volume.
An ordinary pulse then follows the room’s natural and mechanically induced circulation. During an aufguss, a leader additionally redistributes the warm, moist air with a towel or fan. The Swiss Sauna Federation’s January 2026 guideline defines manual aufguss as deliberate evaporation on hot stones together with active distribution by fanning techniques.[12] Its scope is Swiss public facilities and it is an operational guideline, not a controlled fluid-dynamics experiment. Fanning principally changes local velocity and mixing; it does not add water vapour, and a more intense local sensation is not evidence of a higher room-mean temperature. Detailed technique belongs to Steam distribution during aufguss.
Time-resolved measurements are needed to test these processes. Temperature and humidity channels used together should sample the same place and air state; response time, radiation exposure and temporary probe wetting can distort a short pulse. NPL guidance specifically identifies response time and robustness at hot, wet extremes as concerns when rapid humidity changes and condensation may occur.[3] ISO 7726:2025 gives general minimum characteristics and methods for instruments measuring physical environmental quantities, but its public scope supplies neither a sauna-specific sensor position nor a löyly test protocol.[13]
A reproducible investigation records the initial room state, heater and stone arrangement, water mass and temperature, application timing, ventilation, surfaces, occupancy, sensor positions and full time histories. A complete mass balance would additionally measure liquid runoff, exhausted vapour, surface storage and condensate; the retained sauna studies do not do all of these together. Their results support the physical sequence and its variability, but not a formula that turns a ladle volume or one humidity reading into comfort, safety or “good löyly”.
References
- ↑ 1.0 1.1 Kristine Nore, Dimitrios Kraniotis and Christoph Brückner, “The Principles of Sauna Physics”, Energy Procedia, volume 78, 2015, pp. 1907–1912. doi:10.1016/j.egypro.2015.11.361.
- ↑ International Association for the Properties of Water and Steam, Revised Release on the IAPWS Formulation 1995 for the Thermodynamic Properties of Ordinary Water Substance for General and Scientific Use, IAPWS R6-95(2018), release date 21 December 2018, https://iapws.org/technical-guidance/release/IAPWS-95, accessed 4 September 2026.
- ↑ 3.0 3.1 Stephanie Bell, The Beginner’s Guide to Humidity Measurement, Measurement Good Practice Guide No. 124, National Physical Laboratory, May 2013, ISSN 1368-6550, https://eprintspublications.npl.co.uk/7464/1/mgpg124.pdf, accessed 4 September 2026.
- ↑ Finnish Sauna Society, “Sauna heater”, compiled by Raili Vihavainen from Erkki Helamaa, Kiuas, saunan sydän (Rakennustieto, 1999), undated, https://sauna.fi/en/sauna-knowledge/sauna-heater/, accessed 4 September 2026.
- ↑ 5.0 5.1 ASHRAE, “Psychrometrics”, chapter 1 in 2017 ASHRAE Handbook—Fundamentals, https://handbook.ashrae.org/Handbooks/F17/SI/f17_ch01/f17_ch01_si.aspx, accessed 4 September 2026.
- ↑ Erkki Äikäs and Rolf Holmberg, Saunan lämpötilat ja ilmanvaihto [Temperature and ventilation of the Finnish sauna], VTT Research Notes 1431, VTT Technical Research Centre of Finland, Espoo, 1992, 40 pp., ISBN 951-38-4325-4, https://cris.vtt.fi/en/publications/saunan-l%C3%A4mp%C3%B6tilat-ja-ilmanvaihto/, accessed 4 September 2026.
- ↑ E. Helamaa and E. Äikäs, “The secret of good ‘löyly’”, Annals of Clinical Research, volume 20, issue 4, 1988, pp. 224–229. PMID 3218892, https://pubmed.ncbi.nlm.nih.gov/3218892/.
- ↑ 8.0 8.1 Iida Laatikainen-Raussi, Tom Mikkola, Johanna K. Ihalainen and Essi Ahokas, “Temperature and humidity independently influence thermoregulatory responses during Finnish sauna bathing”, Temperature, published online 11 July 2026. doi:10.1080/23328940.2026.2698162.
- ↑ Timo Vesala, “Phase transitions in Finnish sauna”, in Markku Kulmala and Paul E. Wagner (eds), Nucleation and Atmospheric Aerosols 1996, 1996, pp. 403–406. doi:10.1016/B978-008042030-1/50095-0; University of Helsinki research record, https://researchportal.helsinki.fi/en/publications/phase-transitions-in-finnish-sauna/, accessed 4 September 2026.
- ↑ Michael Zech, Stefanie Bösel, Mario Tuthorn, Marianne Benesch, Maren Dubbert, Matthias Cuntz and Bruno Glaser, “Sauna, sweat and science—quantifying the proportion of condensation water versus sweat using a stable water isotope tracer experiment”, Isotopes in Environmental and Health Studies, volume 51, issue 3, 2015, pp. 439–447. doi:10.1080/10256016.2015.1057136.
- ↑ Hikaru Ishibashi, Riku Tomabechi, Kurumu Nishidate, Nanaho Osaka, Tomoki Shimomura, Shoei Yamada, Junnosuke Okajima and Takuma Kogawa, “Evaluation of radiative absorption effect to estimate mean radiant temperature in environments with high water vapor concentration such as in a sauna”, Building and Environment, volume 243, 2023, article 110684. doi:10.1016/j.buildenv.2023.110684.
- ↑ Schweizer Sauna Bund, Fachbereich Aus- und Weiterbildung, Richtlinie RL 25-01—Durchführung manueller Aufgüsse im Saunaraum, version 1.0, January 2026, pp. 7–9, https://mein.fairgate.ch/uploads/11161/documents/RL25-01_Durchf%C3%BChrung_von_manuellen_Aufg%C3%BCssen%282%29.pdf, accessed 4 September 2026.
- ↑ International Organization for Standardization, ISO 7726:2025, Ergonomics of the thermal environment — Instruments for measuring and monitoring physical quantities, edition 3, October 2025, https://www.iso.org/standard/78238.html, accessed 4 September 2026.
