Jump to content

Cleaning a sauna

From RUVARO Sauna Wiki

Cleaning a sauna means the regular removal of sweat, skin oils, dust and water marks from the sauna room — benches, wall and ceiling panels, floor, glass and the outside of the heater — using methods and products that suit hot, mostly untreated wood. It is the foundation of sauna hygiene and sauna maintenance: cleaning removes the visible soil and organic matter first, and only then can any disinfection step work as intended. Commercial routines differ in frequency and documentation and are covered in commercial sauna cleaning.

Principles

Hands wiping a pale wooden sauna bench lengthwise with a wrung-out grey cloth, a soft wooden hand brush beside them and a small bucket with a little water on the lower bench.
Routine cleaning uses little water: a well-wrung cloth or a soft brush worked along the grain of the untreated bench wood, with no hose and no flooding. AI-generated illustration.

Sauna interiors are usually left untreated or treated only with sauna-specific oil or wax so the wood can breathe and tolerate heat. That soft, porous surface is easily damaged by soaking, harsh chemicals and abrasive tools. Three principles therefore govern all sauna cleaning:

  • Use little water. Damp cloths, sponges and soft brushes are the main tools; hoses, pressure washers and streams of water are unsuitable because excess moisture swells the wood, stains it and can damage the structure. Timber specialists warn explicitly never to wash the sauna with running water or a pressure washer.[1]
  • Use suitable products. Slightly alkaline (pH 8–10) sauna-specific cleaners suit wood surfaces; strongly chlorinated, bleaching or solvent-based products do not. Disinfectants and bleach lighten and weaken bench wood, as both heater manufacturers and timber producers warn.[2][1]
  • Always dry and ventilate afterwards. Cleaning without drying causes more harm than no cleaning: residual damp feeds mould and odour. Heating the sauna after cleaning and leaving ventilation open is part of every manufacturer routine.

Washing before entering the sauna, sitting on a seat towel, and throwing water only on the stones rather than on walls or benches reduce soiling far more effectively than any cleaner applied afterwards.

After every session

A short routine after bathing keeps periodic cleaning light:

  1. Remove bench towels, buckets and accessories from the benches.
  2. Wipe water droplets from benches and visible heater surfaces with a damp cloth.
  3. Leave the heater on for roughly 10 minutes to dry the woodwork, open the air vent and leave the door ajar or half open so moisture escapes.[3] In cold weather, close windows and outer-wall valves during drying, since cold outside air does not promote drying.[3]
  4. Once dry, the door may be closed; remove damp textiles from the room rather than drying laundry in the sauna, which is both a fire hazard and a moisture burden.[1]

Wiping high-contact bench surfaces after every use takes minutes and prevents sweat from soaking into the grain — a habit commercial-skincare guidance also stresses for heavily used rooms.[4]

Periodic basic cleaning

For a family sauna in normal use, manufacturers recommend a thorough basic cleaning roughly one to three times a year with a moderate amount of water and detergent.[3][5] A heavily used household sauna reasonably needs it more often; a weekly full clean with regular use plus a monthly deep clean of walls, floor and heater area is a commonly cited rhythm.[4]

A proven bench and panel method, combining several manufacturer guides, runs as follows:

  1. Mix the sauna cleaner as directed — for example about 30 ml of concentrate to 5 litres of warm water — wearing the gloves supplied with care sets.[5]
  2. Wash wood surfaces with a sponge or soft brush, always brushing along the grain, and rinse several times to remove detergent. A final rinse with cold water helps close the grain so it repels dirt.[6]
  3. Treat stubborn dark stains only when the wood is dry, by lightly sanding with fine sandpaper along the full length of the board, then re-treating the sanded area as the oil instructions require.[6][1]
  4. Rinse off residue without saturating the room, then dry the sauna with the heater on and ventilation open — at least 30 minutes of heating is the widely cited figure.[6][1]

Suitable detergents are slightly alkaline products (pH 8–10) made for saunas.[3] The Finnish Sauna Society's hygiene guidance, summarised by trade press, follows the same chemistry: mildly alkaline cleaners for greasy sweat-soil, mildly acidic products for calcium deposits.[7] For light everyday care, plain warm water with a soft cloth, or a strongly diluted mild soap or vinegar solution (roughly one part vinegar to three parts water), is widely recommended for cedar and other softwoods; bleach, ammonia, solvents, oil-based polishes and pressure washers are explicitly unsuitable.[8]

Surfaces in detail

Cutaway drawing of a small sauna room with labels pointing to the benches and backrest, the walls and ceiling, the glazed door, the heater exterior and the tiled floor with duckboards and drain; the stones and heater interior are greyed out.
Where the cleaning effort goes in a sauna room: benches and backrests take the most sweat; walls, ceiling, glass and the cool heater exterior need lighter care; the floor, duckboards and drain come last. Stones and heater internals follow separate routines. Schematic, not to scale.
  • Benches and backrests take the most sweat and need the most attention; clean both accessible sides of removable parts, work with the grain, and avoid soaking end grain.
  • Walls and ceilings need cleaning less often but collect dust and whisk leaves; remove leaves promptly so they do not stain, and wipe rather than flood panels.
  • Floors, duckboards and drains collect the rinse water from every other step; clean them last, lift duckboards, and clear drains so dirty water cannot stand.
  • Glass doors and windows show sweat spray and limescale; use a sauna-suitable or mildly acidic glass cleaner and soft cloth, never abrasive pads on coatings.
  • The heater exterior can be wiped for dust and limescale: light deposits respond to water with vinegar or citric-acid powder, while stainless surfaces suit a dedicated heater cleanser (typically acidic, around pH 3, with about 10–15 minutes dwell time; dampen adjacent tiles first and never combine with chlorinated substances).[9] Internal heater parts, stones and flues belong to heater inspection, heater cleaning and chimney inspection routines, not to cabin cleaning.

A dedicated cleaning brush with soft bristles, kept for the sauna alone, avoids transferring grit or chemicals from household cleaning.

Protection after cleaning

Once clean and fully dry, bench wood can be treated with paraffin oil made for saunas, which reduces moisture and dirt absorption and extends bench life; Harvia recommends treating new benches before first use and repeating once or twice a year at cleaning time, testing the oil first on an inconspicuous spot such as the underside of a bench because it deepens the wood tone.[10] Interior lacquer or ordinary varnish must never be used inside the hot room.[3] Protection, sanding and waxing detail is covered in Sanding sauna benches, Oiling sauna benches and Waxing sauna wood.

Also use the cleaning session for small maintenance: tighten bench screws that have loosened as the wood swelled and shrank, check duckboards and door seals, and note anything — persistent mould, limescale, stains or odours — that needs its specialist routine. Findings feed the maintenance schedule and, where relevant, the risk assessment.

What not to do

  • Do not flood the room, hose it down or use a pressure washer.[1]
  • Do not use bleach, ammonia, solvents, chlorinated disinfectants or abrasive metal tools on wood.[8][2]
  • Do not dry laundry or textiles in the sauna.[1]
  • Do not exceed the heater manufacturer's maximum temperature to "bake" the room clean; excessive heat warps wood and creates a fire hazard.[2]
  • Do not mix acidic and chlorinated cleaners, and keep all chemical bottles out of the hot room during heating.

See also

References

  1. ↑ 1.0 1.1 1.2 1.3 1.4 1.5 1.6 Thermory, Sauna Maintenance, 6 November 2024. Advises damp-cloth wiping, no running water or pressure washer, and drying with the heater on for at least half an hour.
  2. ↑ 2.0 2.1 2.2 SaunaLife, Sauna Care Guide (PDF). Warns that non-compliant agents such as disinfectants bleach the wood surface and may ruin it.
  3. ↑ 3.0 3.1 3.2 3.3 3.4 Harvia Support, Maintaining your sauna (updated 29 January 2026). After-bathing routine, basic-cleaning frequency and detergent pH.
  4. ↑ 4.0 4.1 Saunum, How do you clean and sanitize a sauna steam room safely?, 7 April 2026. Recommends wiping high-contact surfaces after every use, full cleaning weekly with regular use and deep cleaning monthly.
  5. ↑ 5.0 5.1 Harvia, Instructions for sauna care and maintenance (PDF, Y05-1089, September 2023). Gives the 30 ml per 5 litres dosage, pH 8–10 guidance and paraffin-oil treatment.
  6. ↑ 6.0 6.1 6.2 Harvia, Five sauna maintenance tips for getting your sauna ready for summer, harvia.com.
  7. ↑ Theraluxe, Sauna Maintenance 101: Cleaning Do's & Don'ts Every Owner Should Know, 20 August 2026.
  8. ↑ 8.0 8.1 Sun Home Saunas, Sauna Wood Cleaning: Which Products Are Safe for Cedar?, 20 August 2026.
  9. ↑ Harvia, Sauna heater cleanser 500 ml (product instructions).
  10. ↑ Harvia, Paraffin oil for benches 500 ml (product instructions).