Jump to content

Sauna benches

From RUVARO Sauna Wiki

Sauna benches are the fixed or removable surfaces on which people sit or recline inside a sauna room, together with their frames, supports, steps and levels. The system must reconcile posture and usable space with structural loads, heat and moisture exposure, access, heater separation, cleaning and drying. It is not defined by one material, plan shape, number of tiers or sauna tradition.

The Finnish word laude, frequently encountered in sauna literature, has a distinct lexical and cultural range and is treated in Laude. In international English, bench is a functional term. Sauna bench height addresses vertical positioning in detail; this article concerns the bench assembly and its interfaces with the room.

Forms and functions

A bench may serve sitting, reclining or both, depending on its clear length and depth. A complete installation can include a foot level, steps, rails, a backrest and removable sections. Loads may be carried by reinforced walls, floor-standing frames or a combination, whether the system is installed in a Sauna cabin or a site-built room. The visible shape does not reveal the concealed support or its capacity.

A two-level bench with a separate step and labelled supports, shown from the front left.
Surfaces, supports and access components form a bench system. This illustrative arrangement does not specify member sizes or load capacity.

Straight, corner, opposing and U-shaped arrangements allocate wall length, circulation and social orientation differently. Broad raised platforms can place most occupied space at one level while introducing additional steps and access beneath. Finnish specialist Lassi Liikkanen describes these as choices made for a particular room and intended use, rather than a ranked set of solutions.[1]

The same source recommends approximately 600 mm of width and depth per seated adult and notes that an uninterrupted length around two metres can permit reclining in a Finnish planning context.[1] Harvia separately recommends an upper-bench depth of at least 500 mm, or 600 mm for reclining or sitting with the feet on that level.[2] These figures illustrate different specialist and commercial recommendations; they are not universal capacity or accessibility requirements.

Bench form interacts with Sauna layout, movement and usable capacity. Increasing open floor area can shorten seating and add to the heated volume, while extending a platform can obstruct maintenance. A design intended for lying down differs from one serving short seated visits. No retained comparative trial demonstrates that one plan shape is inherently safer, more comfortable or more energy-efficient.

Materials and contact conditions

Timber is common because it can provide workable structural members and contact surfaces, but wood is not a uniform specification. Properties vary by species, grade, grain direction, defects, moisture content and finish. Wood also exchanges moisture with its environment and changes dimension as conditions change. The USDA Wood Handbook describes these relationships, along with their effects on strength, connections and coatings, but does not approve particular species for sauna use.[3]

Two panels of skin pressed against wood and against metal with the same starting temperatures; the contact-temperature marker sits nearer the skin temperature for wood and nearer the material temperature for metal, with a shorter heat arrow for wood.
Why a timber seat feels different from metal at the same surface temperature: on first contact wood exchanges heat with the skin less abruptly because of its lower thermal effusivity. Simplified early-contact model; it sets no burn threshold and does not show that all timber is safe to touch. Schematic.

In a short-contact experiment conducted at approximately room temperature, participants' hands transferred less heat to the tested wood bars than to aluminium or polyethylene, and the wood was generally perceived as warmer.[4] The experiment did not use sauna-temperature benches and cannot establish a burn threshold or prove that all timber remains safe to touch. ISO 13732-1 supplies general methods for assessing contact with hot solid surfaces but sets no sauna-specific surface limit and does not address comfort.[5]

Mineral bench structures occur in some public facilities, sometimes with separate contact surfaces or active cooling. A 2002 project surveyed nine commonly used Helsinki saunas; its detailed one-week comparison followed two public swimming-hall rooms, one with water-cooled ceramic seats and one with timber benches. They differed in size, user load, temperature, condensation and ventilation. Microbial measurements favoured the timber room in that comparison, but the observational contrast cannot show that every wooden bench is more hygienic than every ceramic one.[6]

Structure and room interfaces

Walking, sitting and reclining surfaces transfer loads through frames, wall backing, legs, connections or proprietary brackets. Capacity depends on member geometry, span, connection detail, material condition and the complete load path; a species name or an accessibility test load is not a structural design for the installed system.[3] Manufacturer guidance for wall-mounted benches calls for sturdy supporting structure behind the panelling at the intended attachment locations.[7] Concealed support, fasteners and spans require design for the actual construction and expected loads; this article does not provide a fastening schedule.

An integrated heater is a particularly sensitive interface. Passing a heater through a platform requires the correct opening, flange, guard and clearances for that model.[2] The bench must not be treated as a heater guard, and a guard does not replace the heater's prescribed separation from combustible material. Later changes to either seating or equipment can alter those relationships.

Vertical arrangement is equally important. Bench and foot levels, stones and Sauna ceiling height jointly determine where the body lies within a stratified environment. Finnish discussion sometimes uses the “law of löyly” as a heuristic relating the foot level to the stone bed, but it is not a physical law or worldwide construction rule.[1] Heater geometry, ventilation and sauna type affect the outcome. A bench surface can also have a temperature different from the nearby air, so an air thermometer does not establish contact conditions.

Benches may obstruct or enable access to the floor, drain, heater stones, vents and wall surfaces. Their supports should be coordinated with openings and with whatever removal is necessary for maintenance. Structural alterations belong within the wider Sauna construction process rather than being treated as furniture rearrangement.

Access and ergonomics

Level changes can create a need for steps, handholds or rails, particularly in compact or steep arrangements. Exact geometry depends on the users and on building and accessibility provisions. Higher thermal seating and an accessible transfer bench solve different problems and should not be conflated.

For example, the U.S. Access Board's ADA guide states that where the ADA Standards apply and seating is provided in a sauna, at least one compliant fixed or built-in bench is required. It specifies a seat at least 42 inches long, 20–24 inches deep and 17–19 inches high, clear floor space at one end, and structural-force provisions.[8] Those U.S. transfer and access dimensions are not a specification for an upper bench in every country.

Finnish law separately requires specified common and non-residential sauna facilities to be suitable for people with mobility or functional impairments.[9] That broad duty does not define one global bench dimension. Accessible planning concerns the route into the room, turning and transfer, seating alternatives, controls, assistance and supervision as a system.

Cleaning and maintenance

Cleanability extends to both faces of the seating and the space beneath it. Finnish Sauna Society guidance recommends bench construction that can be washed, ventilated and dried on both sides; liftable or removable elements can improve access when the support design permits them.[10] City of Espoo guidance also identifies accessible under-bench areas and liftable seating as useful features in sauna facilities.[11] Neither source establishes a mandatory gap or removable design for every private room.

Side view of a two-tier sauna bench with backrest battens, foot bench, a lifted removable seat section and a folded seat towel, with labels pointing to the boards, screws, supports, a stained edge and damaged edges to check.
Cleaning and inspection points on a bench: seat boards, battens and supports, screws, both sides of removable sections, stains and damaged edges, the finish and the seat towel. Treatments and procedures depend on the bench's material, finish and manufacturer. Schematic, not to scale.

Cleaning, drying, surface condition and facility use interact. Netherlands public-health guidance requires relevant sauna and wellness furnishings to be cleanable and calls for repair or replacement of damaged water-retaining material in its facility context.[12] Heat alone is not a cleaning programme. Splintering, loose connections, damaged finishes and persistent wetness are grounds for condition-based attention, but no universal replacement interval follows.

Procedures for cleaning, sanding and oiling depend on the material, finish and manufacturer. A treatment suitable for one bench can be inappropriate for another. Maintenance access, light and physical reach should be planned before the system is fixed in place.

Standards and design limits

The Finnish construction-information card RT 91-11258, published in 2017, identifies sauna structures, bench supports, frames, platforms, rails and backrests within its scope, although its paid clauses are not used here.[13] EN 18164:2026 addresses the construction of climated rooms and associated equipment for public wellness use and excludes electrotechnical aspects from its public scope.[14] Neither provides a universal bench plan for every sauna.

Final design must reconcile intended posture and occupancy with structure, heater separation, circulation, access, cleaning and drying. It should use current product instructions and the structural, fire and accessibility requirements applicable to the site. The retained evidence supports no single correct species, finish, height, depth, plan shape or number of levels for all installations.

References

  1. ↑ 1.0 1.1 1.2 Lassi A. Liikkanen, “Lauteiden suunnittelu – lyhyt oppimäärä” [Bench design — a short course], Sauna-lehti, Finnish Sauna Society, 9 February 2023, official article, accessed 4 September 2026.
  2. ↑ 2.0 2.1 Harvia, “What to consider when choosing sauna benches: frequently asked questions”, official manufacturer page, accessed 4 September 2026.
  3. ↑ 3.0 3.1 Robert J. Ross (ed.), Wood Handbook: Wood as an Engineering Material, General Technical Report FPL-GTR-282, USDA Forest Service, Forest Products Laboratory, Madison, revised 2021, official publication page, accessed 4 September 2026.
  4. ↑ Yuko Tsunetsugu and Masaki Sugiyama, “Heat transfer, physiological responses, and subjective perceptions during short contact time with wood or other materials”, Journal of Wood Science, volume 67, article 27, 2021. doi:10.1186/s10086-021-01960-0.
  5. ↑ International Organization for Standardization, ISO 13732-1:2006, Ergonomics of the thermal environment — Methods for the assessment of human responses to contact with surfaces — Part 1: Hot surfaces, edition 1, confirmed 9 May 2022, official record, accessed 4 September 2026.
  6. ↑ Mikko Saari, M.-L. Pallari, M. Salonvaara, H. Kääriäinen, H. Viitanen, K. Laitinen, I. Humala, S. Liski-Markkanen and A. Malin, “Healthy Sauna”, Proceedings of Indoor Air 2002, pp. 394–399, paper PDF, accessed 4 September 2026.
  7. ↑ Harvia, “I am about to start panelling my sauna — what do I need to take into account?”, updated 29 January 2026, official support page, accessed 4 September 2026.
  8. ↑ U.S. Access Board, Chapter 6: Plumbing Elements and Facilities — Saunas and Steam Rooms, ADA Technical Guide, May 2022, pp. 1–6, official PDF, accessed 4 September 2026.
  9. ↑ Government of Finland, Valtioneuvoston asetus rakennuksen esteettömyydestä 241/2017 [Government Decree on Accessibility of Buildings], issued 4 May 2017, effective 1 January 2018, consolidated through amendment 683/2024, especially sections 6, 9 and 11, Finlex record, accessed 4 September 2026.
  10. ↑ Finnish Sauna Society, “About the hygiene of sauna”, compiled by Kirsi Laitinen, University of Helsinki Department of Public Health, official specialist page, accessed 4 September 2026.
  11. ↑ City of Espoo, “Guidelines for operations and planning of premises”, section “Sports facilities and saunas”, official guidance, accessed 4 September 2026.
  12. ↑ RIVM National Centre for Hygiene and Safety, Hygiënerichtlijn voor sauna’s, wellnesscomplexen en zwembaden [Hygiene guideline for saunas, wellness complexes and swimming pools], fully revised 22 May 2025, official guideline, accessed 4 September 2026.
  13. ↑ Rakennustieto, RT 91-11258 / SIT 97-610121: Saunan rakenteet ja lauteet [Sauna structures and benches], guidance card, 12 pp., published 11 May 2017, official record, accessed 4 September 2026.
  14. ↑ Estonian Centre for Standardisation and Accreditation, EVS-EN 18164:2026, Wellness facilities for public use — Climated rooms — Requirements, valid from 16 March 2026, official record, accessed 4 September 2026.

Template:Sauna construction