Jump to content

File:RUVARO sauna tent chimney port interface.svg

From RUVARO Sauna Wiki

RUVARO_sauna_tent_chimney_port_interface.svg (SVG file, nominally 1,332 × 1,998 pixels, file size: 13 KB)

Summary

Partial vertical section through a tent roof and the stove beneath it, showing the roof fabric interrupted by a reinforced port, a heat-shield collar with an annotated gap, an interlocking chimney section joint and a spark arrestor cap above, and below a stove on legs on a non-combustible base with an external stone rack and an ash-pan opening.

The drawing separates three interfaces that the article treats as distinct: the fabric port with its reinforced edge and heat-shield collar, the fit and length of the interlocking chimney sections, and the stone rack with its stone load. A boxed note records that compatibility is system-specific. No clearance, dimension, temperature or weight is shown, because the cited manufacturer instructions apply only to the products they cover.

Source

Made for the RUVARO Sauna Wiki (image plan G01, asset G01-A040). Planned for: Sauna tent. Based on:

Production

  • Method: vector drawing written as SVG code (svg_code), not a raster image.
  • Date: 18 October 2026.
  • Status: draft. Pending review: technical review.

Licensing

© 2026 RUVARO. All rights reserved. This image was made for the RUVARO Sauna Wiki and is the property of RUVARO. No licence is granted for use outside this wiki; reproduction, adaptation or distribution requires prior written permission from RUVARO.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeThumbnailDimensionsUserComment
current11:57, 18 October 2026Thumbnail for version as of 11:57, 18 October 20261,332 × 1,998 (13 KB)Nora van Rossum (talk | contribs)RUVARO image upload

The following page uses this file:

Metadata