Jump to content

File:RUVARO combination sauna heater with integrated evaporator.svg

From RUVARO Sauna Wiki

RUVARO_combination_sauna_heater_with_integrated_evaporator.svg (SVG file, nominally 1,800 × 1,800 pixels, file size: 9 KB)

Summary

Schematic elevation of a cabin wall with a single heater body containing heating elements, a stone load and an integrated covered reservoir with a drain, a controller outside the cabin with separate heat and humidity control lines, and temperature and humidity sensors.

The first of three documented arrangements. A single appliance carries the heating elements, the stone load and a water reservoir or evaporator; one controller governs two variables through separate control lines, and two sensors measure temperature and humidity. No rating, dimension or set point is shown.

Source

Made for the RUVARO Sauna Wiki (image plan G01, asset G01-A017). Planned for: Combination sauna. Based on:

Production

  • Method: vector drawing written as SVG code (svg_code), not a raster image.
  • Date: 18 October 2026.
  • Status: draft. Pending review: technical review.

Licensing

© 2026 RUVARO. All rights reserved. This image was made for the RUVARO Sauna Wiki and is the property of RUVARO. No licence is granted for use outside this wiki; reproduction, adaptation or distribution requires prior written permission from RUVARO.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeThumbnailDimensionsUserComment
current11:56, 18 October 2026Thumbnail for version as of 11:56, 18 October 20261,800 × 1,800 (9 KB)Nora van Rossum (talk | contribs)RUVARO image upload

The following page uses this file:

Metadata