Jump to content

File:RUVARO Sauna sensor cooled by supply air schematic.svg

From RUVARO Sauna Wiki

RUVARO_Sauna_sensor_cooled_by_supply_air_schematic.svg (SVG file, nominally 2,160 × 1,620 pixels, file size: 8 KB)

Summary

Two identical sauna room sections: on the left, supply air ends away from the sensor above the heater; on the right, supply air blows straight onto the sensor and the room is shaded hot, with the steps reads too cool, heater keeps heating, room overheats.

Both panels show the same small sauna room in side section, with a stone heater on the floor, a two-level bench and a small temperature sensor high on the wall above the heater. In the left panel, labelled Sensor as specified, the supply air enters low and bends upward into the room without reaching the sensor, which therefore reads the room. In the right panel, labelled Sensor cooled by supply air, the incoming air flows straight onto the sensor. The sensor reads too cool, the heater keeps heating and the room overheats, shown by warm shading. The left panel is not a recommended vent layout: sensor and vent positions must follow the heater manual.

Source

Made for the RUVARO Sauna Wiki (image plan G09, asset G09-E04). Planned for: Sauna sensor failure, Sauna thermostat failure. Based on:

Production

  • Method: vector drawing written as SVG code (svg_code), not a raster image.
  • Date: 18 October 2026.
  • Status: draft. Pending review: technical review.

Licensing

© 2026 RUVARO. All rights reserved. This image was made for the RUVARO Sauna Wiki and is the property of RUVARO. No licence is granted for use outside this wiki; reproduction, adaptation or distribution requires prior written permission from RUVARO.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeThumbnailDimensionsUserComment
current12:58, 18 October 2026Thumbnail for version as of 12:58, 18 October 20262,160 × 1,620 (8 KB)Nora van Rossum (talk | contribs)RUVARO image upload

The following 2 pages use this file:

Metadata